High pressure cleaner how to maintain, maintain
Bearing Housings,Sn Series,Split Plummer Block,Plummer Block Item HEBEI HAILAN BEARING MANUFACTURE CO.,LTD , https://www.hhbbearing.com
High Pressure Cleaner Care and Maintenance Routine Maintenance - After Each Operation 1. Rinse the hose and filter into the detergent and remove any detergent residue to help prevent corrosion. 2. Shut off the water supply to the pressure washer. 3. Triggering the trigger on the servo gun lever releases all pressure in the hose. 4. Remove the rubber hose and high pressure hose from the pressure washer. 5. Disconnect spark plug connection lead to ensure engine does not start (for engine type). Electric type: Turn the power switch to "on" and "off" position four to five times for 1-3 seconds to clear the water in the pump. This step will help protect the pump from damage. Engine Type: Slowly pull the engine's starting line 5 times to clear the water in the pump. This step will help protect the pump from damage. Periodic Maintenance - Maintained every 2 months 1. Regular removal of fuel deposits from the reservoir will extend the life and performance of the engine. Precipitates of fuel can lead to damage to the fuel lines, fuel filters and carburetors. 2. Protect your pressure washer with a Kelvin pump protection kit (9.558-998.0) when not using a pressure washer. Pump protective cover is especially used to protect the pressure washer against corrosion, premature wear and freeze and so on. And to the valve and seal coated with lubricant to prevent them from getting stuck. Electric type: 1. Turn off the pressure washer. 2. Disconnect the high-pressure hose and servo gun from the pump. 3. Connect the valve to the pump guard and open the valve. 4. Turn on the washing machine; pump all the contents of the tank into the pump. 5. Turn off the washing machine; now the pressure washer can be stored directly. Engine type: 1. Turn off the pressure washer. 2. Disconnect the high-pressure hose and servo gun from the pump. 3. Connect the valve to the pump guard and open the valve. 4. Ignition, pull the start rope; suck all the contents of the tank into the pump. 5. Now the pressure washer can be stored directly.