Single pump room should pay attention to the problem of setting
Sensor Light,Led Wrap Light,Storage Lighting,Basement Light,High Bay Light SHENZHEN LITEHOME OPTOELECTRONIC TECHNOLOGY CO., LTD. , https://www.szlitehomelight.com
In the water supply and drainage design, often encounter water pump house located in the building or outside the building, set up a separate pump room or centralized pump room problem. Properly setting up a water pumping station can not only improve the quality of buildings, but also help developers save a lot of capital investment in equipment and future maintenance and management costs. Xiaobian now to say that a separate pump room should pay attention to the problem of setting. Single pump room In the building block, the pump room is generally located in the bottom, which is the most economical way to set the pipeline short, the overall impact is small. For example, commercial and residential buildings, the following layers are shopping malls, above is residential, set up a separate pump room inside the building, noise has little effect on the house. Because the evening market closed, the noise of the pumping station after several layers of shopping malls on the impact of the above residential has been very small. In this case, it is still possible for the pump house to be located in the building. Such as high-rise residential, living water pump pressure is very large, there are three settings for the pump room: First, the pump room is located on the ground alone, taking into account the maintenance and safety of the pipeline, the pump pipe is generally located in the trench; second pump Room is located under the ground, connected with the basement of the house, but not opposite the house; Third, the pump house is located in residential buildings, but the selection of life pump stainless steel submersible pumps in the pool, or use stainless steel silent pipe pump. All of the above three methods effectively avoid the impact of noise on residential buildings. However, there are some shortcomings of the first method. That is, the pump house is set on the ground alone, which has a great influence on the overall layout of the building. Separate pump room settings should pay attention to the problem 1, first of all, the total figure on the red line to select a place to set up a special pump room. Second, there should be enough pipe to set the pipe ditch. Again, it is also more important to increase investment. 2, pump room is located under the ground, connected with the basement of the house, but not opposite the house. Compared with the first method, this method is similar to the first method. Because the basement is connected, the pump tube can be removed in the basement without the need for ditches, but underground pump room investment is larger than that of the ground pump room. In addition, due to the pump room protruding in the basement area together to the overall figure of the pipeline to bring some trouble. 3, life pump selection of stainless steel submersible pumps in the pool, or use stainless steel silent pipe pump. This method radically improves the noise source. If the use of stainless steel submersible pumps on the pool, but also save the pump room area, which is the most economical way to set up a pump room. However, such a large one-time investment in the pump, if the use of stainless steel submersible pumps on the pool, in case of equipment maintenance, then the impact of a larger area. Further Reading: pump valve pipe fittings Exhibition Water Expo Xiamen exhibition of marine equipment Internet + Forum Yiwu Fair 2016 exhibition mold top ten brands of the Internet information industry (Xiamen) Technology Co., Ltd. Author: Asian pumps Network Editor: Yao Xiaoxia (QQ / WeChat:) http://beng.liuti.cn/ (Service Hotline:)