Water Control Installation Considerations
Engineered Flooring,Engineered Wood Flooring,Engineered Hardwood Flooring,Engineered Oak Flooring Jiangsu Sunyo Flooring Co., Ltd , https://www.woodmapflooring.com
1, the water control device itself has a direction of flow, the installation must pay attention to the direction of the bottom of the water control casing arrow and the direction of the water flow. If there is no swiping water or solenoid valve is not open, it is estimated that the installation direction of the water controller is wrong.
2. It is forbidden to directly input 220V power to the water control machine, otherwise the consequences are your own. Must pass the power adapter to output 12V direct current power supply, positive and negative two lines receive the water control machine power line, if does not show please invert the connection, the water control machine has the circuit protection, the connection will not burn. If the line is not long enough, please extend it by yourself.
3, the water inlet nut of the water control machine should hold the water control machine with one hand when tightening, and hold the nut with one hand and clamp the nut gently, it should not be too hard. The outlet must be held in one hand with a thin arm plate to hold the hex screw, and the other hand to use a wrench to grip the nut and gently apply force. It is forbidden to use brute force, otherwise the consequences are at your own risk.
4. Two sets of water meter connector (nut, copper sleeve, silicone pad) are distributed in the water controller package. Please note that the nuts of the two water meter connectors are not the same. The nut with a higher column is installed in the water control. At the inlet side of the machine, the lower column is installed on the side of the outlet. According to the length of the water control machine, the water meter connector can be connected on both sides of the water pipe, and the water control machine can be tightened.
5, the power supply is best installed in a safe place to install a general electrician socket, not easy to be splashed with water. The power adapter must be firmly attached and not easily fall. Note that the outlet must be dedicated to 220V mains electricity. Unsafe wiring is prohibited.
6. If the water controller is installed in the bathroom or water room, use a large power source for centralized power supply. Please do not install the large power supply in the room and do not install the ceiling. The large power supply voltage is 220V, which is more dangerous, the bathroom water vapor is relatively high, and the large power supply The life cycle will be shortened and unsafe. Please place the big power supply in the outdoor distribution box.