Air generator maintenance and maintenance methods
Foshan City, Nanhai District Huidexing Stainless Steel Products LTD., , https://www.huidexing.net
Air generator maintenance and maintenance methods
1. During the working process, the compressor will not start and the thermal protection relay will start. This indicates that the compressor temperature is too high and it will automatically return to normal after cooling.
2. Because the compressor is an inductive load, the instantaneous current at the time of power-on and power-off is several times higher than that during normal operation. It is easier to blow the fuse and 8A fuse should be used.
3, from the observation window to observe the situation of discoloration of silica gel, the user can replace the new silica gel according to need, or dry.
4. In order to avoid too much water in the Machine and affect the air purity, you need to press the drain switch for a few seconds before shutting down each time. (Drain outlets can be inserted into plastic bottles to avoid splashing out of the water), and daily drainage should not be less than once.
5. In order to ensure the gas purity, the activated carbon needs to be replaced once every 1000 hours of operation of the instrument (20-40 mesh activated carbon, pencil type).
6. Since the compressor is an open-circuit working method, the lubricating oil will be discharged out of the machine with water, resulting in consumption. Therefore, after one year of use, the lubricating oil should be properly added to the compressor. The fuel filling port is next to the compressor outlet (or from the intake air). The mouth can also), it is recommended to add 200 grams of No. 18 refrigerating machine oil.
7. The air inlet filter needs regular cleaning (period depends on the dust situation in the room, ultrasonic cleaning can be used) to keep the air intake unobstructed, otherwise it may cause the compressor's working load to increase and generate heat. When the temperature is too high, overheat protection will occur. Lead to downtime.