Instructions and precautions for hot air desoldering station
The hot air desoldering station is an efficient and practical multifunctional product developed with the development of electronic technology and according to the needs of personnel engaged in research, production and maintenance of electronic products. It adopts the principle of breeze heating to remove tin, which can quickly and cleanly disassemble and weld various types of packaging components. Here we talk about some tips and precautions in the use of hot air desoldering station.  　　 Instructions for use of hot air desoldering station  1. Install and power on Unpack, remove the main unit, and remove the red screw on the bottom of the fuselage. Turn on the 200V power supply, turn on the power switch "POWER", the system can start working. It should be noted that white smoke may be emitted when the hot air tin desoldering station is used for the first time, which is normal. 2. Use of hot head After the power switch is turned on, select different air nozzles and tin suction needles according to the needs, and adjust the hot air temperature adjustment button "HEATER" to the appropriate temperature, and adjust the hot air volume adjustment button "AIRCAPACITY" to the desired air volume as needed. It can be used when the preheating temperature reaches the adjusted temperature. If the hot air head is not used for a short time, the hot air volume adjustment button "AIRCAPACITY" should be adjusted to the minimum, the hot air temperature adjustment button "HEATER" should be adjusted to the middle position, so that the heater is in the state of heat preservation, and the hot air volume adjustment button and hot air are adjusted when it is used The temperature adjustment button is enough. Note: For different packages of integrated circuits, different types of special air nozzles should be replaced; for different solder joint sizes, different air volumes and distances from the air nozzle to the board should be selected. 3. Disassembly skills Disassembly of in-line components: As mentioned above, make the hot air part work normally. Replace the appropriate air nozzle and tin suction pin (with accessories) according to the size of the welding torch, and heat it. According to different circuit board materials and different pads, select the appropriate temperature and air volume. This method is suitable for a variety of single and double-sided circuit boards and solder joints of various sizes.  　　 Precautions for use of hot air desoldering station  Before use, remove the red screw in the center of the chassis, otherwise it will cause serious problems. The ground wire must be connected before use, and the static electricity has been discharged. It is forbidden to put metal conductors in the front mesh of the soldering iron, otherwise it will cause damage to the heating element and electric shock to the human body. Inside the hot air welding gun, there is an overheating automatic protection switch, the gun mouth overheating protection switch is automatically turned on, and the machine stops working. The hot air volume must be adjusted to "AIRCAPACITY" to the maximum. After a delay of about 2 minutes, the heater can work and the machine returns to normal. After use, pay attention to cooling the fuselage. After the power is turned off, the heating tube will automatically emit cold air briefly. During this cooling period, do not unplug the power plug. When not in use, please put the handle on the bracket to prevent accidents. The above is to introduce to my friends about the hot air desoldering station instructions and some precautions in use. Hot air desoldering stations are used very frequently in the electronics industry. He can instantly remove various components, including discrete, double-row and surface mount. And it can be used in one machine, suitable for a variety of occasions requiring thermal energy, such as desoldering a variety of in-line and chip components, heat shrinkable tube processing, thermal energy testing. Full Power Emergency Battery Pack The Full power emergency pack is ideal for LED tubes 3-40W Full power emergency output wattage for LED emergency lighting 60-180mins. Automatic lighting up when main power failures. Suitable for LED fitting with external led driver and internal driver. Widely using for parking lot, office, building, warehouse, school, hospital, workshop etc. Emergency Lighting Battery Pack,Emergency Battery Pack For Led Lights,Emergency Power Packs,Bodine Battery Pack,led battery backup ballast Foshan Nai An Lighting Electric Co.,ltd , https://www.fsnaipsled.com