Problems to be noted when using inspection well level gauges

Problems to be aware of when using a check well level gauge:

1. The waterproof plug between the sensor, wireless transmission and power controller, and battery case should be tightly tightened. To prevent short circuit or open circuit.

2, the cable between the sensor, wireless transmission and power controller, battery box should be attached to the wall and fixed with a line card, if the line will encounter sharp or sharp objects can not be avoided, to protect the sheath.

3. The power must be disconnected before opening the cover.

4. There are fastening screws on the housing. After the operation of the housing is completed, it is necessary to check whether the waterproof sealing strip is intact, and no garbage or particles adhere to the sealing strip. If it is, it needs to be cleaned and then covered. Then close the cover and tighten all the sealing screws.

5. When opening the cover, do not let water, dust, etc. enter the housing, if necessary, clean it up. If necessary, apply 704 glue to increase the sealing performance.

6. Use a wireless transmitter in the sewer. The antenna must be led out of the well. If it can be fixed directly on the ground, the effect is best. If there are cars, people and other rolling around, it is necessary to slot the installation, the depth of the antenna buried in the ground can not exceed 4 cm.

7, do not artificially pull, shake the cable, do not hit the shell.

8. Do not use the connecting cable as a load-bearing cable. Use a connecting cable to suspend the transmitter, battery box, or other heavy objects. The cable must be fixed to the cement wall of the sewer and must not be shaken.

9. It is necessary to put a transparent rubber water pipe on the outside of the cable to protect it.

Global hardware network

Concerned about surprises

Label: Problems to be aware of when using a check well level gauge

Previous: Factors Affecting the Accuracy of Transformer Oil Analysis Gas Chromatograph Next: Classification of Centrifuges

Collect,Collect Bodies,Gas Lenses

Tig Collect,Gas Lens,Collect Body,Tig Weld Collect

Shaodong Lida Tools Co.,Ltd , https://www.hailiweld.com