Shower room installation Raiders
The history of the shower room is much shorter than that of the bathtub, but the shower room is more convenient and sanitary. Therefore, in the decoration of the house, the shower room has become the choice of many citizens. How to install the shower room, Xiaobian to recruit. 1, carefully instructions, and check whether the product parts are complete 2, the shower curtain rod is generally installed at a height of about 2.06 meters from the ground (the specific situation can be determined according to personal habits, as well as the height of the bathroom). Put the shower curtain rod in the position where it needs to be installed, and try to determine the drilling position and make a mark. 3. Drill holes in the wall with a drill bit of 12 mm diameter (drilling depth is about 6 cm). When drilling, let the drill bit slightly down, and the buttocks slightly upward after the drill, which can effectively prevent the shower curtain rod from sagging. 4. Drive the tented wire with the fitting into the wall and tighten the tent. 5. Apply some glass glue on the cylinder according to the assembly (the purpose of coating the glass glue: one is to increase the lubrication, it is easy to install; the other is that after the glass glue is solidified, the shower curtain rod will be more durable). 6. Clean the wall and wipe off the excess glass glue. After 24 hours, it can be used normally.
High purity Polyaluminum chloride PAC 30% supplier
1.PRODUCT APPEARANCE: APPEARANCE: The solid product is produced by the spray drying technology and the obtained product is light yellow, Corresponding liquid products is light yellow.
2.RAW MATERIALS:Domestic high-quality aluminium hydroxide,High-quality calcium aluminate,High-quality hydrochloric acid
3.USAGE: Drinking water treatment Treatment of high-purity water
4.Product Advantages:
1). Flocculation ability, high adsorption activity, floc formation and deposition of fast
5.Storage: The products shall be sealed and stored in the dry and ventilated place to prevent from rain ,high temperature and strong sunlight .
6.Application method:
Water Treatment Chemicals,Waste Water Treatment Chemical,Water Treatment Chemical Shandong Tiancheng Chemical Co., Ltd. , https://www.akdchemical.nl
2). Without alkali and other additives, PH broad in scope, ease of use; for low-temperature, low turbidity, low alkalinity of the raw water is also good flocculation
3).easily to use and good effective
1)The liquid product can be used directly or used after dilution.
Dilution is necessary before used for the solid product. The normal dilution ratio for the solid product is 5%-15%.
2)he specific dosage is based on the flocculation tests and trials by the users. The usual dosage of the liquid product is 3-40 g/ton, and of the solid product, 1-15 g/ton