Washing machine common fault handling method
Confirmat Screw,Confirmat Screws 70Mm,Confirmat Screws Lowes,Confirmat Furniture Screws Hebei W.M fastener manufacturing CO.,Ltd , https://www.wmfasteners.com
When the daily use frequency of the scrubber is relatively high, some minor faults may occur. You can try to handle it yourself, without waiting for the after-sales personnel to come to the door to improve the efficiency of use.
If the washing machine can not walk straight and the floor is not uniform, it is necessary to check whether the pressure of the brush is not enough. If it is, adjust the pressure directly. If not, the problem is that the brush and the scouring pad wear out and the worn parts need to be replaced.
If the battery usage time is too short, you need to check the battery charger or the battery has failed. If you are using a non-maintenance battery, check that the electrolyte is not enough. If so, add distilled water. In addition to this, there may be cases where the electrodes and the terminal are oxidized or covered, in which case it is only necessary to remove oxides and dirt. Another possible situation is that the cleaning area is too large and the battery is overloaded. In this case, a larger capacity battery needs to be replaced. The Rongen series of scrubbers provided by our company adopts the super-wei maintenance-free battery to better ensure the stability of the machine.
If the machine is not working, first check if the power is connected, or if it is not charged in time, the power is not enough to make the machine unable to run. If it is not these problems, then consider it from other aspects.
If the water suction motor does not work, it must be considered in many ways. First of all, you must ensure that your suction pump switch is open and the suction motor power supply is normally connected. Also check to see if the motor fuse has burned out. If it is, just replace the fuse. Another is that the water in the sewage tank is full and needs to be discharged.
Daily maintenance of the scrubber:
1. Empty and clean the recovery tank. During the operation of the machine, a large amount of water mixture containing sludge is taken up, which easily accumulates in the water tank and gives off an unpleasant odor. It is therefore necessary to wash the water tank with running water.
Second, remember to empty the automatic washing machine water tank. In particular, machines with a cleaning frequency lower than once a day may cause the non-flowing water to become a source of bacteria or the like. Water leaks due to incorrect operation, causing unnecessary losses (such as burning the motor).
3. Check if the squeegee of the battery scrubber cleans and cleans the water absorbing filter. One of the squeegee and the water absorbing filter will weaken the blotting effect, and it is necessary to clean the strip and the filter through flowing water.
4. Check the wear of the automatic hand-pushing scrubber brush and squeegee once a week. If the ground friction is large, strong pressure on the ground can damage these attachments or make them wear faster. Under normal circumstances, the brush can be replaced after 50 hours of use. Conversely, after 30 hours of use, the absorbent strip should be replaced or flipped up and down (when the four sides of the strip are still available).
Http://news.chinawj.com.cn