Bearing protection

Home>Bearing knowledge>Bearing protection
/*728*90 created on 2018/5/16*/ var cpro_id = "u3440131";

Bearing protection

Source: Bearing network time: 2014-10-28
/*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089';
First, the method of bearing protection with the oil to wash off the dirty things; then with the protection of lubricating oil; if it is not necessary to lubricate; in the bubble after the oil will soon rust.
It is possible to remove the side cover of the bearing; use the oil to be removed (the gas station sells 15 yuan / bottle) to wash. Wash the oil; can get the needle oil.
If the oil is too sticky; add a little WD-40 is not bad.
However, skating on rainy days is a big taboo; the bearings will rust and ruin.
When the bearing is wet, it must be oiled immediately.
Second, the lubricant (lubricant): protect the bearing, remove the dirt and foreign matter inside the Palin.
Cleaner: hygiene, remove oil (degreaser)
If the bearing does not turn smoothly; there is noise; it may be the bearing into the sand.
If it is not very elegant or lazy; in fact, it can be done; and; once the bearing is removed; wash away the thicker butter; it will become easier to enter the sand; more often in the future.
Third, the device:
Go to the second tank of oil stains. ㄈゼ 韭颍 韭颍 韭颍 韭颍 韭颍 奘逶 奘逶 or other containers (do not use plastic; may dissolve)
A few small containers. ㄓ美捶 鹣 鹣 吹 吹 吹 男 鳎 鳎 鳎 鳎 鳎 鳎 鳎 鳎 . . 鳎 鳎 鳎 鳎 鳎 鳎 撬劬 侵 侵 侵 侵 侵 侵 侵 侵 侵 侵 WD WD WD WD WD WD WD WD And dinosaur 192 spray butter or butter)
Fourth, the process:
Thin (11) acetylene monk swollen sorrel sputum sputum sputum sputum sputum sputum sputum sputum sputum sputum sputum sputum sputum sputum sputum sputum sputum sputum sputum sputum sputum sputum The one of the screws) is forced to dig it down; centering; the bearing is very simple and not bad!
Field (11) throwing ether waves 13. 嗔 砻娴 砻娴 喽魉 簦 簦 簦 簦 簦 悴蛔 獠 獠 獠 獠 獠 15 15 15 础 础 础 础 础 础 15 15 15 15 15 15 15 15 15 15 15 15 15 15 15 15 15 15 15 15 15 15 Xia Weiqiao 嗔 窨 窨 . ..
How to judge? Don't worry! If it is at the margin of the bearing side cover; there is a C-shaped ring; it is detachable; no; it is not broken; but there are exceptions!
.怠(4) 绻 鸬 鸬 鸬 痪 痪 痪 痪 痪 痪 芗虻ダ 芗虻ダ 芗虻ダ 痪 冢 冢 冢 娜 娜 娜 娜 娜 娜 娜 娜 娜 娜 娜 娜 娜 娜 娜 娜 娜 娜 娜 娜 娜 娜 娜Fu. No pan-tubes and smashed 幌孪 幌孪 幌孪 幌孪 昴恪翱赡堋 氚阉 氚阉 氚阉 丁 丁 丁 丁 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 Use a fine screwdriver to extend into the seam of the side cover; forcefully lift the side cover; do not doubt; that's it; but the side cover can't be loaded back! Um; discard it! Remember; just remove one side and it will be ruined!
贰阉 岢 岢 岢 岢 岢 槐卟喔 鹣 鹣 鹣 鹣 枷 枷 枷 枷 枷 枷 枷 枷 枷 枷 枷 枷 枷 枷 枷 枷 枷 枷 枷 枷 枷 枷 枷 枷 枷 枷
Recommend to friends comments close window

Bearing related knowledge
Type and use of equal-section thin-wall bearing holder
SKF bearing alignment function check bearing oil and characteristics four ways to open the rolling bearing bearing use in coal mine occupation


This article links to http://
Please indicate China Bearing Network http://

Previous:Discussion on the processing progress of imported bearing cages:The reason and countermeasures for bearing damage

LED Outdoor Spot Light

Led Outdoor Spot Light,Solar Spot Lights,Outdoor Spotlights,Outdoor Solar Spot Lights

Foshan Brinno Technology Co.,Ltd , https://www.brinnolighting.com