How to brush latex paint more simple brush latex paint should pay attention to what
Now many people like to paint the wall latex paint by themselves. The reason for this is that the latex paint is becoming more and more environmentally friendly. It will not only be harmful to the body, but even some latex paints will also purify methanol. The function of harmful substances. However, the wall paint is a technical job, not to say that you can buy a barrel directly. Today Xiao Bian gave you talk about how to brush latex paint. How to brush latex paint easier 1. Pulp putty, large area of ​​putty (the ratio is: white cement: 107 glue = 10:4) Once again, dry it with sandpaper. A large area is then filled with white cement putty (with the ratio of white cement: 107 glue: talcum powder = 10:4:2), and the whole surface of the board must be flat and then finely ground. 2. Before the emulsion paint is used, the material must be poured into a large container, fully agitated to make it uniform, and stirring must be continued during the use to prevent uneven thickness, uneven packing, or inconsistent color. 3. When the consistency is too large or the “thickening†phenomenon occurs for a long time during storage, the consistency can be reduced by stirring to be fluid and then reused. It is also possible to incorporate paint thinners of no more than 8%. However, it is not possible to add any water to avoid affecting the coating. Film strength. 4. According to the pre-determined construction method, the same batch number should be used, once enough to avoid inconsistent color and consistency and affect the decorative effect, causing inconvenience to the construction. When brushing latex paint, you should pay attention to the following 5 points: 1. The general rule of brushing is from left to right, from top to bottom, first inside and outside, before the first is difficult. 2. The speed of the paint brush should be the same as that of the paint brush. Use even force to ensure uniform coating. 3. Brushing should not be repeated too many times to prevent blistering or leave a brush mark. 4. When the top brush is less oil, the action should be fast, thin brush multiple times to prevent sag. 5. The construction site should be properly ventilated. Looked at the above small series introduced how to brush latex paint is more simple and what should pay attention to brush latex paint, so that you do not become so busy with hands-on, I hope you can like Xiaobian introduction, if you want to know other relevant information, please continue to pay attention This site, more exciting so stay tuned! Latex Paint Green Latex Paint Brand Latex Paint Wall Paint Latex Paint Wall Led Iron Panel Light,Led Round Iron Ceiling Light,Led Ceiling Light Round,Led Adjustable Panel Light Foshan Extrlux Co., Ltd. , https://www.extrlux.com
